View Single Post
Old June 9, 2008, 09:07 AM   #203
carguychris
Senior Member
 
Join Date: October 20, 2007
Location: Richardson, TX
Posts: 7,523
Quote:
kamerer - The revolver carries 6 rounds. The entire length of the gun is only 6" with a barrel length of about 1.25", end of barrel to cylinder is 2". Serial #617XXX.
Left side of the barrel says Smith & Wesson
Right side 32 S. & W. Long.
A bit more info would be nice...

1) Does it have a round butt (RB) or a square butt (SB)?

Illustration: http://www.smith-wesson.com/webapp/w...6303&training=

2) Is there a 2-digit model number inside the yoke? It should be either 30 or 31. (IIRC this serial number may precede model numbers.)

3) Does it have a screw: (a) at the top of the sideplate next to the hammer, (b) at the front of the trigger guard, or (c) on the front of the grip frame about where your ring finger would hold it?

4) Is the front sight a ramp or a rounded blade?

5) How long is the cylinder?
__________________
"Smokey, this is not 'Nam. This is bowling. There are rules... MARK IT ZERO!!" - Walter Sobchak
carguychris is offline  
 
Page generated in 0.03515 seconds with 8 queries