View Single Post
Old February 8, 2016, 12:53 AM   #25
Bill DeShivs
Senior Member
 
Join Date: April 7, 2006
Posts: 10,966
An 8 ft folding table would support a couple of small machines. As long as you run them slow, you shouldn't fling chips off the table. You could glue quarter-round moulding around the edges to keep chips and stuff off the floor.
Take a hard look at Taig lathes and milling machines. They are extremely well made (in the US,) and are inexpensive, precision mini machines.
__________________
Bill DeShivs, Master Cutler
www.billdeshivs.com
Bill DeShivs is offline  
 
Page generated in 0.03007 seconds with 8 queries