View Single Post
Old March 27, 2013, 09:13 PM   #4
Bob Wright
Senior Member
Join Date: July 10, 2012
Location: Memphis, Tennessee
Posts: 2,783
Are you maybe drawing the hammer too far back, then letting it go to half cock? Or lowering it from fully cocked?

If you pass a certain point in drawing the hammer back, the bolt will pop up and lock the cylinder.

Try easing the hammer to half cock from the fired position into the half cock notch and observe the bolt. If it does not snap up, you're good to go.

Bob Wright
Bob Wright is offline  
Page generated in 0.03127 seconds with 8 queries