View Single Post
Old August 16, 2012, 06:13 PM   #10
PA-Joe
Senior Member
 
Join Date: June 9, 2010
Location: NEPA
Posts: 886
When you FL resize you raise the ram with teh shell holder in place and then scree the die down until it touches the shell holder. The you drop the ram and turn the die in another 1/8 turn. To neck size only as others have said back the die out at least 1 full turn and try it. If it doens't resize the neck turn the die in 1/8 until you get the resizing that you want. I would also put a little lube on the case body to stop it from binding on the dies.
PA-Joe is offline  
 
Page generated in 0.04737 seconds with 9 queries