View Single Post
Old August 14, 2012, 06:35 PM   #4
styer
Junior Member
 
Join Date: October 23, 2011
Posts: 3
you both have a good point, i didnt clean the dies, but they look ok. Will do asap.
The bulge is down by the extractor groove, just above it. It was caused by just the nk resize. On another site they said i should wind down the die 1/8 turn down after lowering the ram? Normally you would wind it back up 1/8 of a turn so you dont damage the bullet seater or the die? I did use a graphite powder inside and out on the nk.
Look forward to hearing your thoughts.
Attached Images
File Type: jpg IMG00490-20120814-2030.jpg (100.4 KB, 30 views)
styer is offline  
 
Page generated in 0.03051 seconds with 9 queries