The Firing Line Forums - View Single Post

TheOtherMikey · March 28, 2000, 01:10 AM

You need a bottle of Mpro 70 and a Bore Snake in your favorite gauge. Spray the Bore Snake with the solvent around the brass bristles and about 5 inches below. One pull through should leave your bores looking shiney and bright. Regards, Mikey.

PS: The MPro is non-toxic. It washes out when you wind up the dirty bore snake, wrap around the cord and throw it into your washing machine. Air dry Bore Snakes.

[This message has been edited by TheOtherMikey (edited March 28, 2000).]

March 28, 2000, 01:10 AM	#3
TheOtherMikey Senior Member Join Date: October 16, 1999 Location: Surprise, Arizona, USA Posts: 171	You need a bottle of Mpro 70 and a Bore Snake in your favorite gauge. Spray the Bore Snake with the solvent around the brass bristles and about 5 inches below. One pull through should leave your bores looking shiney and bright. Regards, Mikey. PS: The MPro is non-toxic. It washes out when you wind up the dirty bore snake, wrap around the cord and throw it into your washing machine. Air dry Bore Snakes. [This message has been edited by TheOtherMikey (edited March 28, 2000).]