View Single Post
Old December 31, 2019, 09:38 PM   #217
P Flados
Senior Member
 
Join Date: January 8, 2017
Location: Wilmington NC
Posts: 173
The short web on the starline does sound like a good explanation for the blow out.

However, the extrusion into the ejector hole says there was also an over pressure event. The brass would probably have been "belted" had the entire case wall been fully contained.

All of us 357AR and 350L reloaders are "lab rats" to some extent at this point. I need to go through my brass, find a representative "shortest web" and do something to determine if the case wall is fully contained. Until we better understand the cause of the over pressure events, using cases with walls that are not fully supported is really just plain not smart.
P Flados is offline  
 
Page generated in 0.02650 seconds with 8 queries