View Single Post
Old September 3, 2002, 08:09 PM   #1
p3ordie
Member
 
Join Date: November 18, 2001
Location: SE WI
Posts: 49
9mm for IPSC Production div.

Hello,
I will be going to a IPSC orientation class this weekend. I have a Beretta 96FS and a Ruger P89. I feel my Beretta grip is just a little too big for my hand, and as far a the Ruger goes I can't see compeating with it but I am more acurite with it than my Beretta. So I have been looking for another to start shooting with. Question: Do all rookies start in the production division? If so what would be a good production (9mm) pistol to start off with? I have approx. 600~700 to spend. I was looking at a springfield loaded, but would that put me up against people with 10 times the experience? Any advise would be greatly appreceiated.

p3ordie
p3ordie is offline  
 
Page generated in 0.04011 seconds with 8 queries