Thread: shimming molds?
View Single Post
Old May 24, 2011, 04:01 PM   #8
res45
Senior Member
 
Join Date: September 15, 2007
Location: NC
Posts: 753
Try shooting a cast bullet out of a two groove 303 British if you want an oblong bullet. Depending on the rifles bore you start out with say a .316 dia. bullet to fill the two small grooves and 3/4 of the bullet gets swaged down to fit the two larger .310 lands. Talk about a flat bullet,what amazing is that it still shoots very accurately.

I've Beagled a couple different mold in the past and it's worked fine.
__________________
The Reloaders Network discord Channel
https://discord.gg/Nafuzht
res45 is offline  
 
Page generated in 0.02719 seconds with 8 queries