|
Wrong, each bullet and bullet maker uses a differently shaped bullet and therefore the ogives are not the same. You cannot set the seating die for one bullet and then generically use it for all others.
You should also remove the seating plug and test your bullets to see if it is pushing on the ogive or on the tip of the bullet. With the newer pointed and plastic tips many seating plugs are pushing down on the tip and not the ogive.
If you look at the tips of your bullets you will also notice how inconsistent they are the tip ends get damaged during shipping. You can also measure the length of the bullets and you will notice a lot on inconsitency there.
|