Quote:
Originally Posted by TunnelRat
Usually break-ins don't involve failures to ignite.
Did you check to see if it looked like a light primer strike? Could have been one hard primer.
Sent from my Pixel 2 using Tapatalk
|
I would normally check the primer, but the round ejected over the dividing wall and into the lane when I did my tap-rack. Fired about 75 rounds without issue after the failure, but it seemed odd because I have never had a break-in issue involving failure to ignite. I'm aware that WWB is on the cheaper end of the spectrum, but I've put thousands of rounds through multiple guns without any similar failures. I hold any gun that I plan to carry to a very high standard, and probably won't be comfortable carrying this one until I get a few hundred more flawless rounds through it. At this point I'm mainly trying to learn if it may be a warranty issue.