The Firing Line Forums - View Single Post - Need help with 40S&W Lead Bullet reloading

mrawesome22 · November 3, 2011, 11:16 PM

I would imagine dies are machined on the small side to deal with thin brass, so thick brass and a slightly over sized bullet would make a good visual bulge. They do in my revolver rounds anywho.

But like said, if they chamber you are good to go.

November 3, 2011, 11:16 PM	#6
mrawesome22 Senior Member Join Date: November 9, 2005 Location: Ohio, Appalachia's foothills. Posts: 3,779	I would imagine dies are machined on the small side to deal with thin brass, so thick brass and a slightly over sized bullet would make a good visual bulge. They do in my revolver rounds anywho. But like said, if they chamber you are good to go.