View Single Post
Old May 8, 2017, 10:33 PM   #8
Tinbucket
Senior Member
 
Join Date: January 17, 2015
Posts: 355
I'm impressed with the Ubertis in fit and finish or some anyway.
I've examined a Uberti 1875 Remington and a Colt clone in stainless. Smooth as glass and no clearances it seemed. Lock up was tight at rest or cocked and no end play. Cocking the hammer was jsut so smooth without any discernable play. The loading gates were well tight fitted to but smooth operation. I wondered if a spec of dust or a sneeze would lock them up.
The 4 and 5/8 inch Colt clone in "Case hardened" finish with blue barrel and cylinder was loose as a goose though.
The two stainless guns would put Colt to shame.
Tinbucket is offline  
 
Page generated in 0.02628 seconds with 8 queries