View Single Post
Old February 23, 2021, 12:57 PM   #16
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 18,672
Board member Hummer70 said that when he was a test director at Aberdeen Proving Grounds, they used copper slugs in a fixture to test firing pin energy. The steel fixture was like a headspace gauge but with a primer pocket with a solid floor. A copper slug was set into the pocket and the fixture was chambered and the trigger pulled. The slug was indented by the firing pin (already checked for adequate protrusion) and the depth of the resulting indentation in the copper was measured to determine energy. I assume the slug maker had the equivalent of a copper crusher tarage table for the indentations for depth vs. firing pin energy.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member and Golden Eagle
Unclenick is online now  
 
Page generated in 0.03960 seconds with 8 queries