The Firing Line Forums - View Single Post - Where the heck are all the muzzle crowning tools??

a7mmnut · May 27, 2011, 10:17 AM

???

I've always had them turned in a lathe. It takes a few minutes to grind in a new cutter and indicate for runout, but then it's a breeze. In addition, you can alter the compound tool holder to use various cuts and angles.

-7-

May 27, 2011, 10:17 AM	#11
a7mmnut Junior member Join Date: February 27, 2009 Location: NC Foothills Posts: 1,150	??? I've always had them turned in a lathe. It takes a few minutes to grind in a new cutter and indicate for runout, but then it's a breeze. In addition, you can alter the compound tool holder to use various cuts and angles. -7-