The Firing Line Forums - View Single Post

wachtelhund1 · February 19, 2009, 05:23 PM

TFountain, No advice for a gunsmith but I think most gunsmith should be able to handle the silver soldering. Problem will be not messing up the finish. What do you use for scope base? I have a mint H&K 300 which I purchased just over a year ago. With what I paid for it I wish I had purchased mine in 1985. I could not find an 05 mount, so had a weaver ruger 10/22 base milled flat on the bottom and drilled to match the aligment thread holes in the bases. I used extra long screws that went through the bases into the receiver itself. Not a stock H&K 05 mount, but then it only cost $10.00 and is fast to the receiver.

February 19, 2009, 05:23 PM	#2
wachtelhund1 Senior Member Join Date: January 4, 2007 Location: pelican lake, WI Posts: 413	TFountain, No advice for a gunsmith but I think most gunsmith should be able to handle the silver soldering. Problem will be not messing up the finish. What do you use for scope base? I have a mint H&K 300 which I purchased just over a year ago. With what I paid for it I wish I had purchased mine in 1985. I could not find an 05 mount, so had a weaver ruger 10/22 base milled flat on the bottom and drilled to match the aligment thread holes in the bases. I used extra long screws that went through the bases into the receiver itself. Not a stock H&K 05 mount, but then it only cost $10.00 and is fast to the receiver.