View Single Post
Old June 26, 2005, 05:09 AM   #30
wayneniamat
Member
 
Join Date: June 4, 2005
Posts: 26
Not even three weeks yet and I'm shooting the gun again! The distributor replaced the slide for me and I had the gun in hand on Friday. Put about 700 rounds through it shooting a steel target.

Top notch after-purchase care is what I say about this manufacturer.

The slide is new and different than the last. It has Smith and Wesson stamped on it while the old slide didn't. I don't know if it's my imagination but this slide seems ... weighty. The safety lever looks the same but swivels without as much effort. The two screws that hold the fake compensator have been replaced and are flush now. The finish seems more matte than the original slide.

I made mental note on the way to pick it up that I should get back the correct sight. I had the #2 (lowest sight) on the cracked slide. Sure enough in my eagerness to get the gun home I neglected to check and naturally the #2 is replaced with a #3.

I spent almost four hours on the range Friday. I love shooting this little pistol.
wayneniamat is offline  
 
Page generated in 0.02037 seconds with 8 queries