View Single Post
Old February 8, 2013, 01:01 PM   #10
Walt Sherrill
Senior Member
 
Join Date: February 15, 1999
Location: Winston-Salem, NC USA
Posts: 6,348
I had that "slide stuck on the frame" experience -- primarily because I didn't real the Ghost Trigger Bar instructions as closely as I should have... Felt dumb, after doing it the hard way (removing the pins...)

It's a simple design, but things work differently than you'd expect. Glad to hear you got it worked out. (That little "half" cover in red that comes with the Ghost kit lets you release the striker, which must be done before the slide will come off the frame...)

Memo to me: READ the instructions. Then read them again....
Walt Sherrill is offline  
 
Page generated in 0.03486 seconds with 8 queries