The Firing Line Forums - View Single Post

Lead Express · February 26, 2012, 05:15 PM

Hello again, folks.

I come with yet another question, as I'm exploring a few possibilities of my current setup. I'm really liking the idea of having a powder check die on my press as of recent for ease of use and mind. But the questions is; Where do I put the dang thing. Any suggestions? My setup is very standard and is shown below:

Lee Loadmaster

Loading .357 magnum, .38 special, and .40sw.

Stations:
1-Decap and resize
2-Prime
3-Bell case and powder charge
4-Seat bullet
5-Crimp

How would I fit a powder check die here without going back to crimping and seating at the same time (not as consistent as I like it to be)?

I was thinking of adding a step into station two, but common sense and self preservation tell me that charging whilst priming is a no-no.

Any help is always much appreciated.

February 26, 2012, 05:15 PM	#1
Lead Express Senior Member Join Date: January 21, 2012 Location: Sacramento Posts: 125	Powder check die on a Lee Loadmaster Hello again, folks. I come with yet another question, as I'm exploring a few possibilities of my current setup. I'm really liking the idea of having a powder check die on my press as of recent for ease of use and mind. But the questions is; Where do I put the dang thing. Any suggestions? My setup is very standard and is shown below: Lee Loadmaster Loading .357 magnum, .38 special, and .40sw. Stations: 1-Decap and resize 2-Prime 3-Bell case and powder charge 4-Seat bullet 5-Crimp How would I fit a powder check die here without going back to crimping and seating at the same time (not as consistent as I like it to be)? I was thinking of adding a step into station two, but common sense and self preservation tell me that charging whilst priming is a no-no. Any help is always much appreciated. __________________ ”An unarmed man can only flee from evil, and evil is not overcome by fleeing from it.” ~Col. Jeff Cooper