The Firing Line Forums - View Single Post

thallub · March 8, 2010, 02:57 PM

I heat the screw with a micro torch. This releases the Lock Tite. Then a reverse twist drill bit is used to take out the screw. After a few revolutions of the drill the broken screw usually starts to turn.

http://www.irwin.com/irwin/consumer/...rwinProd100128

March 8, 2010, 02:57 PM	#8
thallub Senior Member Join Date: November 20, 2007 Location: South Western OK Posts: 3,112	I heat the screw with a micro torch. This releases the Lock Tite. Then a reverse twist drill bit is used to take out the screw. After a few revolutions of the drill the broken screw usually starts to turn. http://www.irwin.com/irwin/consumer/...rwinProd100128