The Firing Line Forums - View Single Post - Reloading 7mm Remington mag & .300 Win Mag. Lubricant Options.

Mac284338 · August 9, 2012, 09:18 AM

If you're going to use spray lube be sure and spray cases at an angle sufficient to get some spray in the case mouth. I use the Hornady lube and follow directions on the can holding cases in loading block at 45 degree angle and spraying all sides. This eliminates stuck cases, which you will get if you only spray the outside of the cases. The spray does not contaminate powder and I find it less messy than other products. You can wipe of any excess from the cases after you resize. I've been using it since it came out years ago. I'm new here like you but I've been loading for over 50 years.

Good Luck/be safe/enjoy our hobby.

NRA Life Member

August 9, 2012, 09:18 AM	#15
Mac284338 Member Join Date: August 7, 2012 Location: north Idaho Posts: 22	Spray Lube If you're going to use spray lube be sure and spray cases at an angle sufficient to get some spray in the case mouth. I use the Hornady lube and follow directions on the can holding cases in loading block at 45 degree angle and spraying all sides. This eliminates stuck cases, which you will get if you only spray the outside of the cases. The spray does not contaminate powder and I find it less messy than other products. You can wipe of any excess from the cases after you resize. I've been using it since it came out years ago. I'm new here like you but I've been loading for over 50 years. Good Luck/be safe/enjoy our hobby. NRA Life Member