I actually had a .357 case pull into on the carbide sizing die. Just pulled right into about center ways. Never quite seen that particular failure before. I started using the lube pad again to twirl the very end of the case lightly to get a small 1/16" ring of lube around the case neck. With a carbide die this makes sizing a .357 case feel like it is a .22 magnum case. I now do all my long cases this way, it makes a 45 Colt feel like a 45 ACP in a steel die with lube. BTW I have not had a case failure on my 45 Colt shooting through the RedHawk. MAX loads all the time and the cases just keep going.