View Single Post
Old May 26, 2019, 11:09 AM   #9
Don Fischer
Senior Member
 
Join Date: March 2, 2017
Posts: 1,519
I've had the same thing happen with cast rifle bullet's and inertial puller. Leaves the gas check in the case. O cut open the case and dump the powder attempt to destroy the primer wit oil and throw the case away. Seldom ever load jacketed in a handgun case. If that happened to me I would try drilling a hole in the bottom of the jacket, put a screw in it and then running the case up in the press to where I could get the screw with pliers and pull it. I have both the inertial puller and the collet puller. Much prefer the inertial puller. Both have their draw backs!
Don Fischer is offline  
 
Page generated in 0.04935 seconds with 8 queries