The Firing Line Forums - View Single Post

AL45 · June 28, 2013, 12:57 AM

I was inspecting some rifle brass after I fired it today and noticed on 12 out of 28 pieces, the mouth was slightly pushed in on one side. This is Norma 6.5 mm brass that has been resized to 7.35 mm. The other 16 pieces are round, like they should be. What would cause this and can they be resized without problems?

June 28, 2013, 12:57 AM	#1
AL45 Senior Member Join Date: December 12, 2012 Posts: 761	What's causing this brass problem? I was inspecting some rifle brass after I fired it today and noticed on 12 out of 28 pieces, the mouth was slightly pushed in on one side. This is Norma 6.5 mm brass that has been resized to 7.35 mm. The other 16 pieces are round, like they should be. What would cause this and can they be resized without problems?