Thread: rusting dies
View Single Post
Old July 21, 2012, 03:36 PM   #3
delta tide
Join Date: June 9, 2012
Posts: 35
I had the same thing happen to my new RCBS dies a few months back. It was just surface rust from my fingers where I was handling them. The inside of the dies were fine. I took some "0000" steel wool to them to get the rust off. Then used some Birchwood Casey Barricade on them and stored them inside. Just clean the oil off before use.
"The single biggest problem in communication is the illusion that it has taken place." - George Bernard Shaw

Last edited by delta tide; July 21, 2012 at 05:53 PM.
delta tide is offline  
Page generated in 0.03997 seconds with 8 queries