The Firing Line Forums - View Single Post

Jerry45 · December 12, 2011, 09:16 AM

To remove the extractor you must first remove the rear slide cover. Be very careful or the extractor rod and spring will be launched into oblivion never to be found again. Or worse yet, you’ll poke your eye out. After the cover is off remove the rod and spring assembly. The extractor may fall out. If not remove it. Once the extractor is out the safety/striker block plunger should be removed. It will have a tiny spring accompanying it.

Here’s video. Last part is slide disassembly.

http://www.youtube.com/watch?v=No4SA6v6xjE

December 12, 2011, 09:16 AM	#9
Jerry45 Senior Member Join Date: April 18, 2000 Location: Metairie, Louisiana Posts: 890	To remove the extractor you must first remove the rear slide cover. Be very careful or the extractor rod and spring will be launched into oblivion never to be found again. Or worse yet, you’ll poke your eye out. After the cover is off remove the rod and spring assembly. The extractor may fall out. If not remove it. Once the extractor is out the safety/striker block plunger should be removed. It will have a tiny spring accompanying it. Here’s video. Last part is slide disassembly. http://www.youtube.com/watch?v=No4SA6v6xjE __________________ Guns are not dangerous! People are! RKBA!