I reload in my home ...in a basement shop ...and occasionally a spent primer will roll off the bench / so if it was a carpeted space ..you can vacuum them up. ( I just sweep them up when I'm done on a concrete floor ).
No ventilation is not a problem ...in a climate like yours / you'll be better off keeping your components and loading operation inside your home.
You don't need a lot of space ....regardless of the type of equipment.
I had my loader bolted to a 2" X 24" plank for many yrs - when I lived in apt's and condos - and thru bolted them down to a bench or even to a portable work bench ( like a Black and Decker workmate bench ) ...and when I was done / I'd empty components back into original containers - put a pillow case over loader and put the loader back on a shelf in a closet or the garage for storage.
|