Thread: How about .223?
View Single Post
Old March 22, 2013, 01:11 PM   #24
Jerry45
Senior Member
 
Join Date: April 18, 2000
Location: Metairie, Louisiana
Posts: 890
Quote:
Originally Posted by Clark
The 19 badger is based on the 30 carbine case.
The CZ527 22 hornet barrel is removed and surplussed.
I bought it, worked up loads, and the chamber support did not reach the web.
Before the primer pocket could get loose, the side of the case failed and the gas cutting destroyed the bolt face.

I have rebarreled a number of rifles myself, and so far I have always managed to get chamber support to the case web.

My Pac Nor CZ527 was given a d different feed ramp and the should set back [not by me]. I have not worked a load since and the rifle has gathered dust for years.
Now I understand. I though you blew up factory rifles and ruined the bolts with the ammo the rifle was originally chamber for.

I had a bad batch of primers. Keep blowing holes and pitted the face of my 06 bolt. Still works though.

The only thing I really dislike about the CZ is the scope mount. But then you don't have to worry about bass screw coming loos with the right rings. I'd still rather have it cut for Picatinny/Weaver or screws.
__________________
Guns are not dangerous! People are! RKBA!
Jerry45 is offline  
 
Page generated in 0.02401 seconds with 8 queries