OK, in order asked.
I'm going to look into a seperatge crimp die of some kind because the factory seat/crimp die isn't working for me.
It will be used in a progressive press.
It will be used for both JHPs & plated bullets.
The taper crimp for plated bullets was suggested so I figgured I'd ask. I know that revolvers normally use a roll crimp, but which takes preference roll for revolver or taper for plated?
So I repeat, what type do you suggest assuming I've decided this is the route I want to take I just don't know which of the available options is best for my purposes.
__________________
Allan Quatermain: “Automatic rifles. Who in God's name has automatic rifles”?
Elderly Hunter: “That's dashed unsporting. Probably Belgium.”
|