View Single Post
Old July 29, 2012, 12:39 PM   #48
Senior Member
Join Date: January 27, 2010
Location: Norfolk, VA
Posts: 2,905
If I printed a target then stacked it on red paper, would the red show when a shot was fired?
The bullet is going to penetrate both the target and the red paper, so at most, you're only going to see flecks of the red peeking through the hole.

You can get reactive targets, like the ones made by "Shoot-N-C". These have a black layer over a colored layer. When hit by a bullet, some of the black layer surrounding the bullet hole flakes off, exposing the colored layer underneath:

ScottRiqui is offline  
Page generated in 0.02954 seconds with 8 queries