View Single Post
Old October 25, 2012, 08:47 PM   #20
Eghad
Senior Member
 
Join Date: May 28, 2005
Location: Texas
Posts: 6,231
Back in the day they would heat the metal till it was red hot put it in a container with crushed coal and then put the red hot steel on the carbon and cover it with more crushed coal. let it cool for a while then reheat it till it is glowing red again and quench it in room temp water. I am sure they have some modern solutions. The question is how much time and money are you going to throw at it when I can spend $54.00 and get a considerable improvement in trigger pull with properly specd parts.
__________________
Have a nice day at the range

NRA Life Member
Eghad is offline  
 
Page generated in 0.03351 seconds with 8 queries