View Single Post
Old July 17, 2010, 09:41 PM   #7
rtpzwms
Senior Member
 
Join Date: July 6, 2010
Location: OTS
Posts: 1,023
I had EXACTLY the same problem. Midway and others sell a heavy spring replacement part for the factory part. I think it was about 10 bucks. This will not completely cure the problem you might see one in 50-60 but its so much better than what you're going through. The primers on Wolf are VERY hard and are best used in a SKS of AK type weapon. I'm shooting out the wolf and will not be buying anymore for my Mini30. Also the wolf ammo uses a 311 projectile and the mini would like a 308 but can handle the other. You'll also see the chamber area will start looking red from the paint they used. It can be cleaned out but who wants one more thing to clean out?

I found one site:
http://www.ruger-mini-14-firearms.co...ccessories.php

its listed as a extra power hammer spring.

Last edited by rtpzwms; July 17, 2010 at 10:20 PM.
rtpzwms is offline  
 
Page generated in 0.04645 seconds with 8 queries