The Firing Line Forums - View Single Post - Having a problem with Lee dies and Accurate #2

RepentantMonkey · February 25, 2013, 09:08 PM

Sport45,

Sorry. I misstated the issue. It is with the LOAD DATA that came with the Lee dies, not the dies themselves.

I can up the load to a .37 on the auto disc but I always try to stay in the middle of the load ranges and that would put it right at the max.

And yes ... I measured the loads on a scale.

Accurate #2 said on the can that is is clean burning. 'low pressure' so maybe I will switch to #5 and see how those perform at the recommended loads for that powder.

Thanks!

February 25, 2013, 09:08 PM	#3
RepentantMonkey Junior Member Join Date: June 25, 2007 Posts: 5	Sport45, Sorry. I misstated the issue. It is with the LOAD DATA that came with the Lee dies, not the dies themselves. I can up the load to a .37 on the auto disc but I always try to stay in the middle of the load ranges and that would put it right at the max. And yes ... I measured the loads on a scale. Accurate #2 said on the can that is is clean burning. 'low pressure' so maybe I will switch to #5 and see how those perform at the recommended loads for that powder. Thanks!