The Firing Line Forums - View Single Post

FrankenMauser · July 10, 2012, 05:53 PM

The sprue plate adjustment is handled by a hex-drive screw with a spring washer under it (serving as the hinge pin). It is locked in position by a hex-drive set screw found on the side of the mold block.
-The allen wrenches shown in the photos on the MP website come with each mold, and are for that very purpose.

I don't know anyone that has had to adjust alignment pins in a Miha mold. But if it was needed, they just use an interference fit.

July 10, 2012, 05:53 PM	#9
FrankenMauser Senior Member Join Date: August 25, 2008 Location: In the valley above the plain Posts: 13,424	The sprue plate adjustment is handled by a hex-drive screw with a spring washer under it (serving as the hinge pin). It is locked in position by a hex-drive set screw found on the side of the mold block. -The allen wrenches shown in the photos on the MP website come with each mold, and are for that very purpose. I don't know anyone that has had to adjust alignment pins in a Miha mold. But if it was needed, they just use an interference fit. __________________ Don't even try it. It's even worse than the internet would lead you to believe.