View Single Post
Old January 14, 2000, 06:23 PM   #5
Pierre
Senior Member
 
Join Date: January 10, 2000
Location: Lost Prairie Montana
Posts: 106
On cutting shotgun barrels.........After having been told (by an oltimer years ago) that cutting a mfg'd shotgun barrel could cause it to shoot off axis, we tried that exact scenario on an 870 five years ago. Without even shooting it we could see that the ID was very, very slightly off from dead center! Looking at the mfg'd end, it was exactly on center! Anyone ever seen this? Could this be usual with all or most shotgun barrels?
Pierre is offline  
 
Page generated in 0.04030 seconds with 8 queries