View Single Post
Old November 8, 2018, 02:58 PM   #4
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 6,504
Hot, high pressure metal cutting gas: That could be one problem and then there is high pressure. High pressure will lock it up and make it difficult to lift the bolt handle and make it difficult to extract the case, so it could be necessary to drive the handle up and then drive the handle back.

There is a good chance the extractor will jump the case rim, this will allow you to move the bolt back but the case could be locked-up in the chamber. Anyhow, get as far as you can and then call.

Many years ago Bruce Hodgdon came to out house, my oldest brother had some 270 rounds that were shooting 10' high, getting the bolt open was a workout.

F. Guffey
F. Guffey is offline  
 
Page generated in 0.04723 seconds with 8 queries