View Single Post
Old March 30, 2019, 08:27 AM   #5
Senior Member
Join Date: June 15, 2016
Location: Rural PA
Posts: 1,628
At this point I've gone through the process several dozen times. It seems to me all parts are in where they belong. I suspect something got tweeked ever so slightly.

I did have an "oops" moment the last disassembly before installing the hammer bushing. I was having difficulty removing the barrel/receiver from the grip frame. Per manual instructions, I tapped with a rubber mallet several times before realizing that I still had a magazine in the grip frame. Once the magazine was out, the receiver came right off. It was a rubber mallet and I wasn't pounding on it like a rail spike, but that is the only thing I can think of that may have goofed something up. It's ironic since part of the reason for the modification was to eliminate the magazine from the takedown process.
22lr, 20 gauge, 8mm Mauser, 35 Remington, 30-06, 5.56x45/223, 9mm, 380acp
GarandTd is offline  
Page generated in 0.04360 seconds with 8 queries