View Single Post
Old June 20, 2002, 03:31 PM   #2
C.R.Sam
Senior Member
 
Join Date: October 29, 1999
Location: Dewey, AZ
Posts: 12,858
Were you doing the timing check with the hammer down but the trigger still held all the way to the rear ?

If so....then it is a matter of degree. Very slight out of time is not that big a deal.......getting a gunsmith to check it with a field rod would be a good idea. Perfection is actually rare. But we do like em as close as is affordable.

Also do the recheck with the light from both sides. Sometimes just the angle of the light will show what you are seeing. If the effect switches sides when you move the light to the other side...you ok.


Sam
C.R.Sam is offline  
 
Page generated in 0.03346 seconds with 8 queries