Thread: Savage axis 223
View Single Post
Old January 2, 2019, 09:03 PM   #17
stillquietvoice
Senior Member
 
Join Date: November 13, 2015
Location: UPSTATE NY
Posts: 177
Wendy I've had and worked on both axis and axis 2 triggers, used a g 2 ballpoint pen spring cut to 5 eights inch and a half to three quarter inch bolt with lock nut got 2.5# pull no overtravel.
There is a slight difference between accutrigger and non accutrigger, other than the obvious blade, at the front where sear contacts trigger. The accutrigger has a 45 degree angle at sear contact point regular axis doesn't. I used a 600 grit sharpening stone to smooth trigger surface and sear bevel and removed all creep. It only cost a few dollars and see time.
__________________
actions speak louder than words
flatter tragectories quicker results.
stillquietvoice is offline  
 
Page generated in 0.02907 seconds with 8 queries