The Firing Line Forums - View Single Post

flip180 · October 20, 2005, 03:51 PM

I had my barrel on my VLS floated by a gunsmith but I don't think the channel was seal and the forearm is touching the barrel. I'm going to refloat the barrel and seal the channel off. I picked up a can of (interior) Minwax Fast-Drying polyurethane along with several grit sandpapers and a 1 inch dowel rod. Is the Minwax OK? If so, how best to apply it as far as how many coats and over what time?

Thanks, Flip.

October 20, 2005, 03:51 PM	#1
flip180 Member Join Date: October 5, 2005 Posts: 75	Is minwax OK to seal a barrel channel? I had my barrel on my VLS floated by a gunsmith but I don't think the channel was seal and the forearm is touching the barrel. I'm going to refloat the barrel and seal the channel off. I picked up a can of (interior) Minwax Fast-Drying polyurethane along with several grit sandpapers and a 1 inch dowel rod. Is the Minwax OK? If so, how best to apply it as far as how many coats and over what time? Thanks, Flip.