The Firing Line Forums - View Single Post

Wayward · May 5, 2001, 04:11 PM

I'm using the RCBS turret press. You just need to use the primming system enough to loosen it up. I process in batches. I'll decap/size/prime in one operation. Rotate the turret to the belling die and bell all my cases. I then put those preped case away until I'm ready to do a marathon charging/bullet seating session

. When I'm ready to charge/seat I'll load up 2 loading blocks (50 rounds each) and charge all 100. Then I seat the 100 and keep alternating between loading the blocks/charging and bullet seating until I've done all the preped cases. Finally I rotate the turret to the Lee FCD (when applicable) and factory size/crimp all the loaded rounds.

May 5, 2001, 04:11 PM	#5
Wayward Member Join Date: November 18, 2000 Location: Texas Posts: 79	I'm using the RCBS turret press. You just need to use the primming system enough to loosen it up. I process in batches. I'll decap/size/prime in one operation. Rotate the turret to the belling die and bell all my cases. I then put those preped case away until I'm ready to do a marathon charging/bullet seating session . When I'm ready to charge/seat I'll load up 2 loading blocks (50 rounds each) and charge all 100. Then I seat the 100 and keep alternating between loading the blocks/charging and bullet seating until I've done all the preped cases. Finally I rotate the turret to the Lee FCD (when applicable) and factory size/crimp all the loaded rounds.