View Single Post
Old April 14, 2010, 08:45 PM   #8
FrankenMauser
Senior Member
 
Join Date: August 25, 2008
Location: 1B ID
Posts: 10,390
I think it's extractor snap-over.

However, ADIDAS69 makes a good point:
Quote:
If the case neck isn't machined parallel to the head and secondarily that inaccuracy makes the case too long at that point
It IS Winchester brass. I have not seen a straight case mouth on Winchester brass in about 10 years. Everything is under trim-to length on one side, and over max length on the other (high side versus low side of the crooked mouth).

Check your case length, and squareness of the mouth.
__________________
"Such is the strange way that man works -- first he virtually destroys a species and then does everything in his power to restore it."
FrankenMauser is offline  
 
Page generated in 0.03297 seconds with 8 queries