View Single Post
Old May 22, 2013, 08:26 PM   #31
polyphemus
Senior Member
 
Join Date: June 24, 2012
Posts: 1,055
" I've seen it in my own guns only in my 10mm,"
I was under the impression that this thread was about M1911 firing pin spring
isues.
Anyway,as I pointed out previously the M1911 firing pin is pushed back by the
cartridge upon firing,as the extractor holds the cartridge,the ejector flips it out
it does not drag it up the breech face.Something may be binding the firing pin
I don't doubt that,but I would like to see a picture of such indentation in a .45
ACP cartridge primer cap fired in an M1911.
polyphemus is offline  
 
Page generated in 0.03683 seconds with 8 queries