View Single Post
Old May 14, 2022, 10:02 PM   #26
tangolima
Senior Member
 
Join Date: September 28, 2013
Posts: 2,755
Ok it is near the lowest point of the ram travel. That's when the expander ball trays to expand the neck. First I would make sure the expander ball is low enough, away from the neck of the die. Or the brass will get caught between the expander ball and neck of the die. Next is to make sure you have adequate lube inside the brass. The critical area is under the shoulder and inside the neck. If necessary I apply imperial wax there with Q tip.

Hope this helps.

-TL

Sent from my SM-N960U using Tapatalk
tangolima is offline  
 
Page generated in 0.02956 seconds with 8 queries