The Firing Line Forums - View Single Post - How many of you fuss with crimped primer brass?

Joe-ker · February 10, 2017, 04:51 PM

I buy it 2,500 to 3,000 pounds at a time.

Holy cow Jeephammer!!!!!!

. You're a small army LOL! But seriously, thanks for all the replies. I think I'll just stick to my hand reamer for the little amount I plan on doing. I was a little concerned about reaming too much and primers might not have a deep enough pocket. I've been checking them by sliding a paper clip to make sure there is a smooth edge on the pocket and quitting there.

February 10, 2017, 04:51 PM	#17
Joe-ker Senior Member Join Date: September 6, 2016 Location: North Iowa Posts: 247	I buy it 2,500 to 3,000 pounds at a time. Holy cow Jeephammer!!!!!!. You're a small army LOL! But seriously, thanks for all the replies. I think I'll just stick to my hand reamer for the little amount I plan on doing. I was a little concerned about reaming too much and primers might not have a deep enough pocket. I've been checking them by sliding a paper clip to make sure there is a smooth edge on the pocket and quitting there. __________________ From my cold dead hands.....