View Single Post
Old December 7, 2010, 10:25 AM   #3
Senior Member
Join Date: July 15, 2006
Location: Fern Creek ,KY and Metro Louisville at large
Posts: 426
Pillar bedding basically is you remove stock material around the action screws and replace it with harder material ie brass , aluminum or Plastic.
The common way is too drill out holes in stock with a bigger drill bit and pour in metal reinforced epoxy glue ( steel bed or j/b weld)
CW Shooters Supply Inc
Machine Shop and Finishing Services to the trade and public
guncrank is offline  
Page generated in 0.04434 seconds with 8 queries