View Single Post
Old October 8, 2005, 12:52 PM   #4
DeltaWhiskey
Senior Member
 
Join Date: April 13, 2005
Posts: 226
Thanks for all of your replies. Got the piece stripped down enough to see what I needed to see. Couldn't remove the cylinder bas pin from the front. had to take a brass punch and tap it from the hole in the rear of the frame and out through the fromt. My friend's dad appears to have abused this revolver a bit in the past.
__________________
"I'm DeltaWhiskey on the other forums, too."
DeltaWhiskey is offline  
 
Page generated in 0.03749 seconds with 8 queries