The Firing Line Forums - View Single Post

Dixie Gunsmithing · July 2, 2013, 10:00 AM

The pin should be flush on the outside toward you, with the end sticking out into the slot inside, forming the cam. If its sticking out to the outside, use a punch, and small hammer to tap it back flush.

July 2, 2013, 10:00 AM	#32
Dixie Gunsmithing Moderator Emeritus Join Date: April 27, 2013 Location: Ohio Posts: 1,923	The pin should be flush on the outside toward you, with the end sticking out into the slot inside, forming the cam. If its sticking out to the outside, use a punch, and small hammer to tap it back flush.