Thread: 44 mag loads
View Single Post
Old March 20, 1999, 02:48 AM   #6
Walt Welch
Senior Member
 
Join Date: November 3, 1998
Location: Alamo, CA
Posts: 424
Here is the way to obtain the best loading data. First, go to Shooter's Gunlinks:

http://www.shooters.com/gunlinks/index.htm

Then, look up the powder company in which you have interest. Most of these are found in the 'Product Manufacturers, non-Firearm' section. Hodgdon makes Clays powder, so look them up:

http://www.hodgdon.com/ is the website you will find. Look for reloading info, and you will be at a site where you can pick out data, then pistol data. Select .44Mag, and you are at:

http://www.hodgdon.com/data/pistol/44magpistol.htm#top

This website gives you data for Universal (Universal Clays), HS-6, HS-7, and H-110, among others, for various bullet types and weights.

Suppose you want to look up data for W-231, or other Winchester powders. Go to the same site, Product Manufacturers, non-firearm (another company makes Winchester rifles now), and click on Winchester, you will be at:

http://www.winchester.com/ look for reloading data, and you will end up here:

http://www.winchester.com/reloader/index.html

You will find there a 1.3 Meg downloadable file, which you can read on site if you prefer, and it has loads for W296 and W231, in the .44 Mag. on p. 48. I will warn you that the W231 loads are very hot, and would suggest you consult some other data sources following the same methods as above for reduced loads. Be advised that reducing W296 charges is not recommended. This is a powder very similar to H-110 (not coincidentally also manufactured by Olin, who makes W296); reduced loads with H-110 are strictly limited to a 3% reduction maximum.

Obtaining data in this fashion is the safest way to do it. You are sure you are getting the latest data from the manufacturer. Use printed reloading manuals for confirmation of the load (that is, make sure the load you got from the mfr.'s site is close to what is in the manuals. If the manual says to use more powder than the mfr. does, DO NOT do so. Take the powder manufacturer's data as maximimum).

I have used both H-110 and W231 in the .44 Mag with good results. Use magnum primers with H-110, and crimp heavily to avoid bullet creep. I use regular primers with mild loads of W231, and do not crimp so heavily. Good luck, and happy reloading. Walt
Walt Welch is offline  
 
Page generated in 0.03768 seconds with 8 queries