The Firing Line Forums - View Single Post

William_IV · March 4, 2005, 02:16 PM

coal =1.155 this is a full profile jacket, the bullet shank is .2370 long before
tapering off to a point. Bullet diameter is .4510. Should I just crimp them a littl tighter untill they don't move in the casing.

March 4, 2005, 02:16 PM	#6
William_IV Member Join Date: March 4, 2005 Location: Phoenix AZ Posts: 76	C.o.a.l coal =1.155 this is a full profile jacket, the bullet shank is .2370 long before tapering off to a point. Bullet diameter is .4510. Should I just crimp them a littl tighter untill they don't move in the casing.